Samsung 300k Tool Error 995

I have searched stackoverflow and googled thoroughly for this problem but not been able to find a clue to why this problem is happening. I am writing a program in C++ which communicates with a measurement device connected through USB. The program is multithreaded and several threads will communicate with the device. A mutex is used to guarantee that no two threads try to read or write from the device at the same time.

Samsung 300k Download Mode Tool 1000 Tested Free Download. Samsung Galaxy S9 / S9 Plus Telekom Magenta Mobil M / M Young ab eff 995 € mtl Allnet-Flat SMS-Flat. Have been a Samsung user on/off for the last couple of years. I think the phones are. When I hit OK, it then reads, 'Error: Network Error'. Seriously, what gives.

Xrgamedll dlya stalker zov pripyati fajl. JSGME serves the purpose of your launcher request. You can update them individually if they need it. You just put all addons in their own separate folders and configure their install order.

Commands are sent to the device using and the responses and measured values are read using - both operations are done synchronously. Sometimes while reading the measured value from the device will the measurement fail with a timeout (GetLastError() returns error code 121), due to a synchronization error inside the measurement device itself - which is ok and expected. When I try to continue the measurement, by sending a new command will WriteFile sometimes (roughly 50% of the time) fail and GetLastError() returns the error code 995 which is described in MSDN as: ERROR_OPERATION_ABORTED 995 (0x3E3) The I/O operation has been aborted because of either a thread exit or an application request. There is no thread exit after the timeout occurs and there is no cancel of any read or write operation.

I am able to resume the communication only by closing and re-opening the communication with the device using CloseHandle and CreateFile. However, this will take some time from the measurement and is not an ideal solution. My question is, why does WriteFile return the error code 995 in this case, and what can I do to avoid having to close and re-open the communication with the device?